Pump Control

These days your smart phone does more than make calls, it has become a critical management tool. We leverage that reality by offering options to control irrigation pumps directly from MyFarm.

Product Profiles

PC-100 Pump Controller w/ Flowmeter Monitor

The PC-100 provides the ability to control electric engine irrigation pumps through its SDI-12 interface and is intended for use with the Agility® Sensor Radio and the MyFarm web application. It includes a pulse counting input and a 4-20 mA current loop input for use with flowmeters to measure flow rates at the pump. It can be paired with the CM-82000/83000-AS to provide flowmeter monitoring for those pumps.

Features:
  • Flow Meter Monitoring
  • Latching Relay for Electric Motor Control
Specifications
  • Operating Voltage: 24 VAC or 12 VDC
  • Flow meter Open Collector Pulse Counter (Over voltage and E.S.D. protected)
    • O. C. High Side Input (with pull up (4.7 K) to 12VDC)
    • O. C. GND
  • Flow meter 4-20 mA Current (Over voltage and E.S.D. protected)
  • Latching Relay (RT424F05)
    • DPDT
    • 8 A
    • 250 VAC

CM-82000/83000-AS Diesel Engine Controller w/ Autostart

The CM-82000-AS is a rugged microprocessor-based engine controller for mechanical diesel engines. The CM-83000-AS works with the more modern electronic J1939 engines.  They include an Autostart feature that allows control from the Agility® Sensor Radio via the MyFarm web application. The Autostart feature can be programmed with independent start and stop sequences to allow for start at a low RPM with gradual throttle increase over time to operating RPM and gradual throttle decrease over time to idle for turbo cool down .

Features:
  • Advanced throttle control
  • Engine manufacturer specific logic
  • Auto shutdown
  • Clutch control 
  • Assignable input and output configuration
  • Quick set-up programming
  • Engine identification
  • Alarm logging
  • Maintenance intervals
  • Battery recharge logic
  • Proprietary CAN Bus communications (CM-83000-AS)
  • Real time clock auto start and stop scheduling
  • Mod Bus start and stop with speed control
  • Level and pressure maintain and monitoring
  • Feeder logic
Specifications
  • Operating Voltage: 5.5 VDC to 36 VDC Maximum Current
  • Consumption AT 12.6V: 50mA
  • Operating Temp: -40°C to 80°C (-40°F to 176°F)
  • Storage Temp: -40°C to 80°C (-40°F to 176°F
  • Reverse Polarity Protection: Yes
  • Transient Voltage Suppression: Yes
  • Load Dump Protection: Yes
  • Display: OLED, 1”H X 4”W (2 lines x 16 characters/line)
  • Standard/Metric Display: Selectable
  • Enclosure: Polycarbonate- IP68
  • Overlay/Interface: Autotex Polyester Keypad Tactile Stainless Steel Domes
  • Approx. Weight: 6.0 lbs
  • Approx. Dimensions: 8” H x 10” W x 4” D